Halfen Anchoring Systems

Halfen Technical Manual







	Dynagrip Toothed Anchor Channels
	HALFEN Technical Manual
	Table of Contents
	Introduction
	Anchor Channels
	Page 09 Page 28
	Page 10 Page 29
	Page 11 Page 30
	Page 12 Page 31
	Page 13 Page 32
	Page 14 Page 33
	Page 15 Page 34
	Page 16 Page 35
	Page 17 Page 36
	Page 18 Page 37
	Page 19 Page 38
	Page 20 Page 39
	Page 21 Page 40
	Page 22 Page 41
	Page 23 Page 42
	Page 24 Page 43
	Page 25 Page 44
	Page 26 Page 45
	Page 27 Page 46
	Fasteners
	Channel Profiles
	Miscellaneous

ANCHOR CHANNELS - Page 10

SiteMap

Previous Page

Next Page

Printable Page

These illustrations are full-size profiles of the anchor channel bodies shown in this manual.

9/16"
(15mm)

2815 HTA Series Anchor Channels. Part numbers start with HT2...
(See page 13)

1 1/8" (28mm)

5/8"
(38mm)

3817 HTA Series Anchor Channels. Part numbers start with HT3...
(See page 15)

1 1/2" (38mm)

7/8"
(22mm)

4022 HTA Series Anchor Channels. Part numbers start with HT4...
(See page 17)

1 9/16" (40mm)

7/8"
(22mm)

4122 HTA Series Anchor Channels. Part numbers start with HT9...
(See page 19)

1 5/8" (44mm)

13/16"
(21mm)

4122 HZA Series Toothed Anchor Channels. Part numbers start with HZ9...
(See page 21)

1 5/8" (41mm)

1 5/8"
(41mm)

4141 HTA Series Anchor Channels. Part numbers start with HT0...
(See page 23)

Use these charts to make preliminary selections of anchor channels, then use information on the applicable page to complete the design.

1 5/8" (41mm)

Home - General - Technical - Glazing - Precast - Masonry - Stone - Engineering - Stainless - Software - Specs - About - Contact - Literature